///Cylinder over-temperature warning or shutdown
Direct-drive plunger pumps
Cylinder over-temperature warning or shutdown
Heat at a cylinder means high-pressure water leaks inside that cylinder.
Safety first: Switch off the pump, release all pressure (open the on/off valve or bleed-down valve) and lock out before you open any high-pressure part. Never put a hand or tool near a running jet.
1Quick questionsYour answers put the most likely cause on top.
Is the warning on one cylinder or all?
2Check the causes, most likely first
0 of 3 checked
01Dynamic seal failing
Most likely
The plunger seal leaks and heats the cylinder.
How to check: Check pump hours and fit the maintenance kit.
| Photo | Art. no. | Description | Excl. VAT | |
|---|---|---|---|---|
 | 10377 | End Cap Wrench, 8007923
KMT |
€ 70.80 | |
 | 10511 | Dynamic Seal Assembly, SLPRO, 90K, 20479499
AssemblyKMT |
€ 159.60 | |
 | 11104 | Maintenance kit, KMT intensifier tools, 05072723
Repair kitKMT |
€ 898.80 | |
 | 12661 | Dynamic seal kit - Hyplex Prime, 050626-1
Seal kitKMT, Flow |
€ 95.00 | |
 | 11489 | Swivel maintenance kit, 007117-1
Repair kitFlow |
€ 274.80 |
02Debris under outlet or inlet poppet
Possible
A held-open poppet lets water flow back.
How to check: Inspect check valve poppets and seats.
03Inlet water too warm
Less likely
Warm inlet water (above about 18 °C) shortens seal life.
How to check: Measure inlet water temperature.
Related problems
General advice based on manufacturer manuals and service practice. Always follow the manual of your machine. Not sure? .