///Burr on the bottom edge
Cut quality & parts
Burr on the bottom edge
Burr usually means the jet energy at the bottom is too low.
Safety first: Switch off the pump, release all pressure (open the on/off valve or bleed-down valve) and lock out before you open any high-pressure part. Never put a hand or tool near a running jet.
1Check the causes, most likely first
0 of 2 checked
01Worn focusing tube
Most likely
A worn tube gives a weaker jet.
How to check: Replace the tube.
| Photo | Art. no. | Description | Excl. VAT | |
|---|---|---|---|---|
| 10324 | Focusing tube 9.45 x 1.02 x 102
Focusing tubeKMT |
€ 129.00 | ||
 | 10867 | Focusing Tube 9.45 x 0.76 x 76.2, 05097944
Focusing tubeKMT |
€ 75.50 | |
| 10968 | Focusing Tube 9.45 x 1.02 x 76.2, 49835390
Focusing tubeKMT |
€ 75.50 | ||
| 10969 | Focusing Tube 9.45 x 0.91 x 76.2, 05116652
Focusing tubeKMT |
€ 77.02 | ||
| 11677 | Focusing tube 9.45 x 0.76 x 102
Focusing tubeKMT |
€ 129.00 |
02Wrong abrasive grain
Possible
Size affects the bottom edge.
How to check: Check mesh size.
Related problems
General advice based on manufacturer manuals and service practice. Always follow the manual of your machine. Not sure? .